Difference between revisions of "SDIN Boards"
From RobolaboWiki
| Line 64: | Line 64: | ||
<h1> Eclipse Environment </h1> | <h1> Eclipse Environment </h1> | ||
It is mandatory to install the Base Environment first | It is mandatory to install the Base Environment first | ||
| + | |||
| + | <h2> Install Eclipse </h2> | ||
| + | |||
| + | Download last version of Eclipse IDE for C/C++ Developers from: http://www.eclipse.org/downloads/ | ||
| + | |||
| + | <h2> Import Project </h2> | ||
| + | |||
| + | <h2> Set OpenOCD </h2> | ||
| + | |||
| + | <h2> Set GDB </h2> | ||
Revision as of 22:36, 18 February 2016
Contents
Base Environment
Install Compiler gcc-arm-none-eabi
Download last version of GCC ARM Embedded from: https://launchpad.net/gcc-arm-embedded/+download
Untar the compiler:
tar -xvjf gcc-arm-none-eabi-<VERSION>.tar.bz2
Copy it to a common place:
sudo cp -r gcc-arm-none-eabi-<VERSION> /opt/compilerNucleoST
Install OpenOCD On-Chip Debugger
Instal dependencies:
sudo apt-get install flex bison libgmp3-dev libmpfr-dev libncurses5-dev libmpc-dev autoconf texinfo build-essential \\ libftdi-dev libusb-1.0-0-dev libexpat1-dev
Download last version of Openocd from: http://openocd.org/
Untar openocd:
tar -xvzf openocd-<VERSION>.tar.gz
Go into the directory:
cd openocd-<VERSION>
Configure openocd compilation:
./configure --prefix=/opt/openocd/ --enable-jlink --enable-amtjtagaccel --enable-ftdi --enable-buspirate --enable-stlink \\ --enable-ftdi --enable-rlink
Compile it:
make
Install:
sudo make install
Prepare its use according to udev:
sudo cp -r contrib/openocd.rules /etc/udev/rules.d/90-jtag.rules sudo udevadm control --reload-rules
Eclipse Environment
It is mandatory to install the Base Environment first
Install Eclipse
Download last version of Eclipse IDE for C/C++ Developers from: http://www.eclipse.org/downloads/
