PhantomX Reactor Robot

From RobolaboWiki
Revision as of 08:23, 17 October 2016 by Aguti (Talk | contribs)

Jump to: navigation, search

Note: Most of the information of this website is obtained from: http://learn.trossenrobotics.com/projects/182-arbotix-getting-started-guide-arduino-ide-1-6-x-setup.html Please refer to the previuos link if you need more information.

Configuring the environment

Setting up the Arduino Software

  • Download the Arduino IDE 1.6.x according to your operating system from: https://www.arduino.cc/en/Main/Software .
  • Install the Arduino IDE
    • If you have chosen to download the installer, run the installer and install the software in a path of your convenience.
    • If you have chosen to download the sources (Linux or zip on Windows), uncompress the software in a path of your convenience
  • Open/run Arduino IDE, so it will create all the folders needed
  • Close Arduino IDE

Installing Tools and Libraries

  • Download the robot libraries from: here .
  • Uncompress the libraries to a path of your convenience. In this file you will find two folders: hardware and libraries
  • Copy both folders to the <ARDUINO_MAIN_DIRECTORY>. In some Windows you will find this folder in My Documents\Arduino\ , while in others you will find it in Documents\Arduino\ . In Linux you will find this folder in ~/Arduino/.
    Important: If you already have a libraries folder inside your <ARDUINO_MAIN_DIRECTORY>, move the content of the libraries folder downloaded inside the libraries folder of <ARDUINO_MAIN_DIRECTORY>.

Check installation

  • Open/run Arduino IDE
  • Open a Robot Test:
  •  
    File -> Examples -->ArbotiX --> Tests --> ReactorTest
    
  • Select the Arbotix board
  • Tools -> Board -> ArbotiX Std
    
  • Compile the program
  • Program-> Verify/Compile
    

    If there is no errors, you are ready for the next step. If you found some errors, please review the previous steps.

  • Close Arduino IDE

Hello World example

Compiling the code

Downloading the code to the robot

Installing FTDI drivers

If you are using Linux or Mac, skip this step. If you are using Windows, power up the robot and connect it to your computer. Windows should ask you to install some FTDI drivers to be able to connect to the robot.