Difference between revisions of "Nucleo Boards"
From RobolaboWiki
| Line 58: | Line 58: | ||
Prepare its use according to udev: | Prepare its use according to udev: | ||
<pre> | <pre> | ||
| − | sudo cp -r contrib/openocd. | + | sudo cp -r contrib/99-openocd.rules /etc/udev/rules.d/ |
sudo udevadm control --reload-rules | sudo udevadm control --reload-rules | ||
</pre> | </pre> | ||
Revision as of 21:32, 17 November 2015
Configuring the environment
Install Compiler gc-arm-none-eabi
Download last version of GCC ARM Embedded from: https://launchpad.net/gcc-arm-embedded/+download
Untar the compiler:
tar -xvjf gcc-arm-none-eabi-<VERSION>.tar.bz2
Copy it to a common place:
sudo cp -r gcc-arm-none-eabi-<VERSION> /opt/compilerNucleoST
Install OpenOCD On-Chip Debugger
Instal dependencies:
sudo apt-get install flex bison libgmp3-dev libmpfr-dev libncurses5-dev libmpc-dev autoconf texinfo build-essential \\ libftdi-dev libusb-1.0-0-dev libexpat1-dev
Download last version of Openocd from: http://openocd.org/
Untar openocd:
tar -xvzf openocd-<VERSION>.tar.gz
Go into the directory:
cd openocd-<VERSION>
Configure openocd compilation:
./configure --prefix=/opt/openocd/ --enable-jlink --enable-amtjtagaccel --enable-ftdi --enable-buspirate --enable-stlink \\ --enable-ftdi --enable-rlink
Compile it:
make
Install:
sudo make install
Prepare its use according to udev:
sudo cp -r contrib/99-openocd.rules /etc/udev/rules.d/ sudo udevadm control --reload-rules
